![]() Some USB ports found on older devices do not support USB 2.0. Remember that the USB charging cable requires a high power (USB 2.0 or better) port. The CORSAIR HS55 WIRELESS headset battery has no “memory effect”, so there is no need to completely discharge it before recharging. Connect the USB charging cable to the CORSAIR HS55 WIRELESS Headset.Connect the USB charging cable to any working USB port on your PC.The CORSAIR HS55 WIRELESS headset must be fully charged before its first use. In addition, pressing the volume wheel cycles through four audio EQ presets: Standard, Bass Boost, Movie Theater, and FPS Competition. Use the volume control/EQ select wheel to adjust volume up or down. A 30-degree bend is a good place to start, but you can adjust this if your mic is too loud or too soft. Alternatively, you can use the mute button on the headset.įor best performance, bend the flexible microphone boom to best fit near the left corner of your mouth. MICROPHONE CONTROLįlip-up microphone to mute. Take breaks between sessions and always begin with the volume at a low level before increasing. NOTE: Prolonged listening at high volumes may adversely affect your hearing. Keep the headset at room temperature (20-30☌ or 68-86☏).Battery life is maximized by keeping the battery in a partially charged state. Do not leave the battery fully discharged for long periods.Make sure the battery is fully charged before initial use.Place the wireless USB receiver in an open, unobstructed area.To skip backwards, press the MFB three times quickly. To skip forward, press the MFB twice quickly. To pause playback, single press the MFB again. To end the call, single press the MFB again. To answer an incoming call, single press the MFB. The headset will default to the last mode it was set to when turned off. Quick press the power button to enter Bluetooth mode and enable both phone calls and Bluetooth audio (such as when listening to music). ![]() Note when the headset is in RF wireless mode and paired via Bluetooth with a mobile phone, it will only accept and receive phone calls. When the headset is in RF wireless mode the status LED will blink red, orange or green depending on the current battery level. Quick press the power button to toggle between RF wireless and Bluetooth modes. When the headset is paired, the status LED will blink blue. With the headset powered on, enable pairing by holding the MFB until the status LED rapid blinks red and blue. Dolby, Dolby Audio and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation. Manufactured under license from Dolby Laboratories. The software’s built-in documentation explains how to use the headset’s features in greater detail.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |